Plastic Industry

ASACLEAN
Mueller Prost
Precision Color Compounds
Routsis Training
Grainger
ID additives
5 Folds
IQMS
Aurora Plastics
Screen Tech Designs
PolySource
Conair
AMCO Polymers
M Holland
Tooling Docs
RJG, Inc.
Mold Building Services
Stout
ChemTrend
Frigel
Royal Technologies

MAPP Plastics Discussion Forum

The MAPP Plastic Industry Discussion Forum allows members to rapidly communicate with each other. Post both questions and answers to questions that other MAPP members have about any industry topic from material and process issues to R&E Tax Credits and other business issues.

Username:  Password:  
Remember Me
Forgot Your Password?
Plastic Industry Forum - Converse with Plastics Processing Leaders / Equipment / Surface Finish & Measurement Equipment Needed
Posted:  07 Oct 2014 21:55   Last Edited By: Stoneridge, Inc.
I am looking for suggestions on equipment that can scan a black 33% GF Nylon 6/6 valve seat surface and give us dimensional and finish measurements. The seat is about 14mm below the datum. I need to measure that depth, parallelism of the seat to the datum, flatness of the seat, and the surface finish (roughly 0.8).

I need something relatively fast and easy to use in a production inspection room environment (not on the floor, but not in a lab either).

Has anyone specified something like this? If so, could you point me in the right direction?

Thanks!

James Henson
Posted:  09 Oct 2014 21:29
Hi James,

I cannot say for sure what would be your best bet for equipment necessary, but the following information is who I would generally call.  They carry a wide array of measurement options.
Zach Hamilton
Metrology Center
Cell - 630.270.9455
Office - 630.968.4243
www.metrologycenter.com     

Regards,
Jim
© 2014 Manufacturers Association of Plastics Processors