Plastic Industry

M Holland
Mueller Prost
PolySource
Precision Color Compounds
Tooling Docs
Screen Tech Designs
AMCO Polymers
ID additives
Aurora Plastics
ASACLEAN
Mold Building Services
5 Folds
Conair
Royal Technologies
Frigel
ChemTrend
Routsis Training
IQMS
Stout
RJG, Inc.
Grainger

MAPP Plastics Discussion Forum

The MAPP Plastic Industry Discussion Forum allows members to rapidly communicate with each other. Post both questions and answers to questions that other MAPP members have about any industry topic from material and process issues to R&E Tax Credits and other business issues.

Username:  Password:  
Remember Me
Forgot Your Password?
Plastic Industry Forum - Converse with Plastics Processing Leaders / Equipment / Needed. Sampling press for tool tryout 200 ton vertical/vertical rotory.
Posted:  28 Mar 2016 20:23
Sample Molding Time Wanted;

We are looking for a 200 ton vertical clamp / vertical  injection unit on a rotary table to sample our new mold.  Early May is when we would like 3 -4 days of support and the beginning of June for 3-4 days.. The shot size is 128 cm^3 using a glass filled polyester. We will be insert molding terminals for this trial and is one of the primary reasons for the Vertical clamp configuration.  The injection rate we are looking for is 400 cm^3 / sec to fill the 4 cavities. If the available machine does not have this capability, we can still utilize the press anyway. The mold has a hot runner system and we will provide our own 240 Volt control unit. The process will require at least one thermolator for 170 F water temperature and we will also require a dehumidifying dryer. Finally, the table size required is 1600 mm with a base weight of 800 pounds, the “A” side weighs about 1700 pounds.  Mold size is 18.5 x 34.5 x 23 inches tall. Please contact us for further arrangements.


Tom Katchmar
© 2014 Manufacturers Association of Plastics Processors