Plastic Industry

M Holland
Grainger
Tooling Docs
Frigel
Routsis Training
Conair
Royal Technologies
Precision Color Compounds
IQMS
AMCO Polymers
5 Folds
Screen Tech Designs
Aurora Plastics
Stout
Mueller Prost
ID additives
PolySource
RJG, Inc.
Mold Building Services
ChemTrend
ASACLEAN

MAPP Plastics Discussion Forum

The MAPP Plastic Industry Discussion Forum allows members to rapidly communicate with each other. Post both questions and answers to questions that other MAPP members have about any industry topic from material and process issues to R&E Tax Credits and other business issues.

Username:  Password:  
Remember Me
Forgot Your Password?
Plastic Industry Forum - Converse with Plastics Processing Leaders / Business / Injection Molder Needed for Short Run Job
Posted:  04 Jun 2008 18:37   Last Edited By: Admin
Can anyone help me?  We have an injection molding job in need of a 1500 Ton injection molding press.  The EAU is approximately 2000 pieces.  We will need about 200 pieces per month.  Also, we need a quote on the the following tool?  See attachments & information below.

Sonya C. Cloyd
Materials Manager
DeKalb Molded Plastics
Butler, IN   46721
Ph (260) 868 - 2105 ext 324


Please see attached info on the 32” bezel.

The tool drawings show only 4 gates, but it has 8.

Gates need to be trimmed near flush to the surface.  (We currently have a spec. of -0/+.020”)

The overall shot is 5.5# with runner.

Material is Polymer Resources PC ABS FR2

The run sheet for the 1000T shows where we were – it ran, but had some flash.

Minimum clamp should be something in the 1500 to 1800T range.

Photo
Image 2
Image 3
Image 4
Image 5
© 2014 Manufacturers Association of Plastics Processors